Syhood 3/8”-Gong AR500 Steel Targets Hanging Kit Include 3 Pcs 3.94″/5.91″/7.87″ Metal Steel Shooting Targets 6 Pcs Hang Hooks 2 Pack Leg Brackets 4 Pack Wire Lock Pins

what our customer say this product:

Powered by

1. Dillard E Prestidge Verified Buyer – 23 May 2024

   Well made, they look. The ratio is 1.154. So I bought 2, 10’X3/4” conduit. Cut the legs 40”, that makes the height 34.5”. After cutting 4 legs it leaves you an 80” peace for top bar. You can use that or cut to length you want. If you want a different height like, 48” . 48 X 1.154=55.392. So the legs would be 55” to get you close. 34.5” tall was the tallest I could get without buying a third piece of conduit. Hope this helps,
   

2. Philip Verified Buyer – 16 October 2024

   Nothing better than the sound of the gong!
   

3. Jake Verified Buyer – 24 October 2024

   Best money I ever spent on a target set. It will last a long time before it gets old.
   The set up is easy and the targets can take a lot of strikes with almost no wear. A can of spray paint and they are ready for the next day.
   I used 10 ft lengths of 1 inch ID conduit and cut them to 5 ft lengths for the legs. Then used one 7 ft length for the cross piece.
   Very sturdy and easy to transport and assemble.
   

4. chlngr Verified Buyer – 28 November 2024

   The plates were great! Made it through one solid range day! The hangers on the other hand, only two survived, and I’d say barely! We used .22 up to 7.62×54! Would suggest different hangers! One plates hangers hole got broke off as well! Still great targets!

   

5. T. Owen Verified Buyer – 14 February 2025

   I bought (3) 10’ pieces of 1” EMT, cut all 3 at 60” and drilled each for redundancy. I measured by holding the leg joint on the bench and marking the pipe. Then drilled the ends with a pilot but then a 1/4” through hole and that worked well. Set up is easy and if you pull tension on the legs it’s very solid. At 60” legs, the top bar is 49” and center of md and lg targets is 40”. I tested with my G19 co2 BB pistol with fresh cartridge and the coating (grey for me) is not as durable as expected. I’ll be adding a can of paint to the range box, which was the plan all along. Next, I’ll add 1” rubber knob-end as feet to keep the pipe from filling with dirt. Otherwise happy with the project. Be safe.

   

6. Sean Satzman Verified Buyer – 2 March 2025

   Sound good when you hit them
   

7. Jim Mathews Verified Buyer – 4 March 2025

   Used 3/4 ent for the legs and 1” rigid for the bar. Works great good value.
   

8. Robert H. Verified Buyer – 22 March 2025

   Cut one inch EMT into 5 ft sticks you Will need five pieces and the targets are 3/8 thick 9 mm or 357 do not even put a dent in them and I accidentally shot one of the hooks with 9 mm and all it did was bend the hook in a little bit solid steel doesn’t lie and this is the cheapest setup if you do it right and drill the holes and put the pins in it’s pretty dang solid