YUANYGBH Flux G17 Fixed Stock, Black

what our customer say this product:

Powered by

1. Nicholas Verified Buyer – 17 May 2024

   Ok so it needed lots of sanding right above where it grabs the rail. Fits extremely tight and it squeezes the rail and frame into the spring lug on the front of the slide. Won’t cycle into battery until “fit”. The bars are thin and flimsy. Flex heavily being shouldered. And bend after firing. Lowe’s has 1/16” flat bar and you can cut and grind and thin out your own replacements. Lots of work for 99$. But a legit on ___broker is 3-4x the $. Probably great for airsoft. Not great in Minecraft. Can be made to work.
   

2. AJ Verified Buyer – 15 June 2024

   Rear piece Had to be alter significantly to fit front piece had to be installed with a rubber mallet, for so tightly that it prevents cycling of device. Trash product, do not buy.
   

3. Mr. R. HOLMES Verified Buyer – 8 January 2025

   solid and work fine for my gun
   

4. J. Perry Verified Buyer – 4 March 2025

   Seems well made and sturdy, but will not fit a Gen 3 G19.
   

5. Perez Verified Buyer – 16 March 2025

   Perfecto
   

6. SHL0M0 Verified Buyer – 17 March 2025

   I took a chance on this one for a psa dagger and am actually pretty happy with it. It definitely requires fitting, I had to Dremel and sand the rear piece to get it to line up properly, but I don’t mind a bit of work because of how inexpensive it is. My main complaint is that the metal rods do seem a bit flimsy, but I will try to make some replacements with hardware store parts.

   Overall not too bad, just know what you are getting into and be prepared to modify it to make it fit.
   

7. Jordan lang Verified Buyer – 27 March 2025

   Pretty rough, needs a lot of sanding to get to fit properly. The pin it comes with is way too small so ill have to figure something out

   Update: the bars for the stock warped basically immediately. So now the only positive is that the flashmag (foregrip/magholder) is fine after a bunch of dremel work and since the real one is unobtanium now this is the closest you’ll get
   

8. Ralph B Verified Buyer – 6 April 2025

   Probably best for airsoft.
   Pretty sure it’s only for the Gen4 17, because it’s hitting the ambi slide stop on my Gen5.
   Rear pin hole doesn’t line up properly but you can make it work.
   The brace bars are very flimsy and bend easily.
   Worth the 90 bucks just for cool factor, but don’t expect to get any real use from it.